Thursday, February 28, 2019

Week 4: 2-28-19













   









This week we finished coding for our second lap of the figure 8 and it worked!! However, we do need to make some alterations in order to make the run consistent every time, so today we went ahead and started on perfecting the coding. Despite our setbacks with our SolidWorks alterations due to the V5 structure, we finished our SolidWorks square-bot build. Along with the challenge and our SolidWorks build, I completed the blogs and made sure they were all in place.

Published by Jacklynn




at

No comments:

Post a Comment

Subscribe to: Post Comments (Atom)

Week 14: 5-24-19

This week we accomplished a lot. We officially completed the autonomous tetrahedron challenge and we started... AND completed the tank ...

  • Week 13: 5-10-19
    So... we did two of three of our officials Monday and it didn't go as well as we thought it was going to. So today we did a couple ...
  • Week 9: 4-11-19
    Our robot is officially completely built for the challenge. This week we added the claw and got the coding for it wor...
  • Week 10: 4-17-19
    So... we didn't end up figuring out how to change the speed, but for future challenges we'll keep researching. This week we...